![]() The remote control door lock receiver only functions as an antenna, receivingĮntry transmitter and forwarding them to the body control module (BCM). REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING AND SETUP If the ECU still cannot be programmed, replace the ECU.Turn the ignition ON and attempt to reprogram the ECU.If the ECU can still not be programmed, turn the ignition OFF for at.Ensure that all ECU, DLC and programmingĪnd the TIS terminal operating software is up to date. In the event of an interrupted or unsuccessful programming event, perform the To reprogram an existing control module, perform the following procedure: At the end of programming, choose the "Clear All DTCs" function on the.Programming and follow the on-screen instructions.Īnd Configuration follow the on-screen instructions. NOTE: The Rear Differential Clutch Control Module can now be Prepare the Control Module for Removal and follow the on-screen On the SPS Supported Controllers screen, select RDCM Rear Differential.After completing the step, the Rear Differential Clutch Control NOTE: The next step will copy the 2 digit rear differential clutchĬalibration value from the old module and store it in the computer's hardĭrive. Access the Service Programming System (SPS) and follow the on-screen.Install EL-49642 SPS programming support tool.To program a replacement control module, perform the following procedure: If replacing the rear differential clutch assembly and keeping the oldīe configured with the number stamped on the housing using a scan tool.Ifīe established, the number stamped on the rear differential housing can be Into the new Rear Differential Clutch Control Module using SPS. In the RDCM memory and stamped on the rear differential housing. If replacing the Rear Differential Clutch Control Module, the moduleĭifferential clutch service calibration value.Set the Inspection/Maintenance (I/M) system status indicators to NO. Clear DTCs after programming is complete.During the programming procedure, follow the SPS prompts for the.Such as interior lights, exterior lights (including daytime running Turn OFF or disable systems that may put a load on the vehicles. ![]() Not available, connect a fully charged 12 V jumper or booster packĭisconnected from the AC voltage supply. ![]() The EL-49642 SPS programming support tool to maintain system voltage. Spiking, over voltage or loss of voltage will interrupt programming.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |